Remote Control Setting Menu - Selco WF 110 Betriebsanweisung

ARC AIR
MAIN MENU QUICK MENU
Current set Current set
Current reading
Voltage reading Voltage reading
SET-UP MENU CH1 RC07
TIG LIFT
MAIN MENU QUICK MENU
Current set Current set
Current reading
Voltage reading Voltage reading
SET-UP MENU CH1 RC07
*** the maximum current value depends on the power source (PSM408=400A, PSM508=500A, PSM708=limited to 500A).

1.3.9 Remote control setting menu

From the set-up menu with parameters no. 45 and 46, by pres-
sing the encoder E1 key, a further menu can be accessed for set-
ting the minimum and maximum values associated with the two
channels of the remote control RC07.
A typical screen for channel 1 appears as follows:
At the top a symbol that identifies the channel (CH1 or CH2) and
a symbol that associates the parameter with the channel are dis-
played. Association of the parameters with the two channels is
fixed for each welding procedure.
The following two lines display the minimum and maximum
values that can be selected and set via the encoder E1.
Description of keys
* Encoder E1: allows you to select the MIN/MAX parameter and
set the value.
By pressing the encoder E1 you select the parameter you wish
to modify.
By rotating the encoder E1 you change the value of the selec-
ted parameter.
* Key K3: cancels the modifications made, restoring the pre-
vious values, and returns to the set-up list selection.
* Key K4: quit and return to the set-up menu, with storage of
the modifications.
SET-UP MENU SYMBOL
2-Current set
3- Arc detachment threshold
4- Anti-stick enable
40-Current reading
41-Voltage reading
48-Buzzer tone
49-LCD contrast
45-CH1: min current set
RC07
45-CH1: max current set
RC07
SET-UP MENU SYMBOL
2-Current set
3- Arc detachment threshold
40-Current reading
41-Voltage reading
48-Buzzer tone
49-LCD contrast
45-CH1: min current set
RC07
45-CH1: max current set
RC07
Remote control RC07
The remote control is plug and play, and therefore in order to
enable it, the potentiometers must be set with values different
from 0 "zero".
Naturally with the remote control enabled, it is not possible to
modify the remote parameters via encoder E1 from any menu.
To exclude operation of the remote control RC07 and re-enable
the parameters with the encoder E1, set both knobs of the remo-
te control RC07 to minimum.
When the remote control is enabled, instead of the two para-
meters of the main menu, a screen will appear displaying the last
parameter regulated and its value.
The screen appears as follows:
MIN MAX DEF
6 Imax *** 100
Off (19) 49 Off (19)
Off (0) On (1) On (1)
- - -
- - -
Off (0) 10 5
0 50 25
6 max-1 6
min+1 Imax *** Imax ***
MIN MAX DEF
6 Imax *** 100
Off (19) 49 Off (19)
- - -
- - -
Off (0) 10 5
0 50 25
6 max-1 6
min+1 Imax *** Imax ***
UM
A
V
-
A
V
-
-
A
A
UM
A
V
A
V
-
-
A
A
31