Cleaning; Storage; Transportation - Hecht 8220 Bedienungsanleitung

A
CAUTION!
Use protective gloves during this step and while handling the cutting blade. Risk of
cutting!
• Install the saw blade in the opposite way.

CLEANING

A
CAUTION!
Never spray the product with water or expose it to water.
C Never use aggressive detergents or solvents for cleaning.
1. Carefully clean the machine after each use.
2. Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water. Never use aggressive detergents or solvents for cleaning. This
can cause irreparable damage to the product.
3. Wipe down the product with a slightly damp cloth or with brush.
4. Clean the cover of the machine, especially the ventilation holes.
5. If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry. Then the metal parts must be grease against the corrosion with suitable
protective oil. Make sure that the water doesn´t leak into the internal parts of the machine.
6. Potential damage of the parts due to corrosion, can not be assessed as a manufacturing or
material defect.

STORAGE

• Store the machine out of reach of children.
• Turn the motor off and disconnect the mains plug if the machine is not used.
• Allow let the machine to cool down before storage.
• Do not store the machine a long time in direct sunlight.
• Replace worn or damaged parts for safety.
• Store machine in a clean, dry, dark and frost-free place, protected from dust and out of
reach of children. The ideal storage temperature is between 5 and 30°C.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.

TRANSPORTATION

• Turn the motor off and disconnect the mains plug. When transporting, be careful not to
drop, or otherwise shock the machine. For transport, the machine has to be fixed against
slipping and tipping over. Do not place objects on the machine.
• The saw is equipped with two wheels for easier handling.
• Push the cutting frame (feeder) toward the disc until it touches the stopper. Secure it with
the lock latch. Stand the saw and tilt it towards you (on wheels). When tilting use the wheel
brakes and make sure the machine isn't over-weighed and doesn't overturn on you.
• Don't handle the saw with a wood inserted.
EN
DE
CS
SK
PL
HU
29 / 36