Cleaning And Care - Klarstein VINOVILLA 50 DUO Bedienungsanleitung

CLEANING AND CARE

Cleaning
• Before cleaning your appliance (something to be done regularly), disconnect it
by removing the plug or by pulling the fuse on the circuit.
• Before using your appliance for the first time and regularly after that, we
recommend that you clean the inside and outside (front, sides and top) with
warm water mixed with a gentle cleaning product. Rinse with clean water and
allow to dry before reconnecting. Do not use solvents or abrasives.
• When the appliance is switched on for the first time, there may be a residual
odour. In that case, run the appliance empty for a few hours at the coldest
possible temperature. The cold will kills any odours.
• Wash the plastic coating on the steel shelves with a mild detergent solution.
Storaging your winecooler
If you will not be using your appliance for short periods, leave the control panel
with its usual settings.
During an extended shutdown:
•
• Remove all bottles from the appliance
• Unplug the appliance
• Thoroughly clean the inside and outside of the appliance
• Leave the door open to prevent condensation, unpleasant odours and mould.
What to do in the event of a power cut
Most power cuts are resolved within a short time. A power cut of 1 or 2 hours will
not affect the temperature in your cellar. To protect your wines during a power cut,
avoid opening the door as much as possible. During very long power cuts, take the
necessary measures to protect your wine.
• If the appliance is disconnected or if there is a power cut, you must wait three
to five minutes before re- starting. If you try to re-start before this time, the
compressor will only re-start after 3 to 5 minutes (if the temperature requires).
• When switching on for the first time or following a prolonged shutdown, it is
possible that when re-starting, the temperatures selected and those displayed
are not the same. This is normal. It will take a few hours before they stabilise.
If you need to move your wine cooler
1. First, disconnect your appliance.
2. Remove all bottles and secure any loose parts.
3. To avoid damaging the levelling screws on the feet, screw them tightly into the
base.
4. Move the appliance in an upright position (preferably) or note the direction in
which the appliance may be laid down by looking at its packaging.
EN
45