Stihl TSA 230 Gebrauchsanleitung Seite 52

English
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
If the LEDs on the battery flash or glow red – see
"If the red LEDs glow continuously / flash".
1)
When charging: Charge process starts automatically after the battery has cooled down / warmed up.
2)
During operation: Machine cuts out – allow battery to cool down; it may be necessary to take the
battery out of the machine for this purpose.
3)
Electromagnetic problem or fault. Take the battery out of the machine tool and refit it. Switch on the
machine – if the LEDs continue to flash, the battery is faulty and must be replaced.
4)
Electromagnetic problem or fault. Take the battery out of the machine. Use a blunt tool to remove
dirt from the contacts in the battery compartment. Refit the battery. Switch on the machine – if the light
emitting diodes still flash, the machine is faulty and must be checked by a servicing dealer – STIHL
recommends an authorized STIHL servicing dealer.
52
12.3 If the red LEDs glow continu‐
ously / flash
A
B
C
D
A 1 LED glows con‐
tinuously red:
B 4 LEDs flash red
C 3 LEDs glow con‐
tinuously red:
D 3 LEDs flash red
12 LEDs on Battery
Battery is too
1) 2) 1)
hot /cold
Malfunction in
3)
battery
Machine is
too hot –
allow it to
cool down.
Malfunction in
4)
machine
0458-707-9821-C