Stihl TSA 230 Gebrauchsanleitung Seite 44

English
5.7 Cutting pipes, round and hollow
bodies
► Secure pipes, round and hollow bodies
against vibrations, slipping and rolling away
► Note direction of fall and weight of the severed
part
► Determine and mark the cutting line, avoid
reinforcements, especially in the direction of
the severing cut
► Determine sequence of severing cuts
► Cut a guide groove along the line marked
► Make cut deeper along the guide groove –
observe the recommended cutting depth for
each operation – for small corrections of direc‐
tion, do not tilt the abrasive cutting wheel, but
always position it anew instead – if necessary,
leave small ridges that hold the part that is to
be separated in position. Break these ridges
after the last planned cut
5.8 Cutting concrete pipe
The procedure is dependent on the outer diame‐
ter of the pipe and the maximum possible cutting
depth of the abrasive cutting wheel (A).
► Secure pipe against vibrations, slipping and
rolling away
► Note weight, tension and direction of fall of the
part to be severed
► Determine and mark direction of cut
► Determine sequence of cuts
44
Outer diameter is smaller than the maximum cut‐
ting depth
► Make one cut from the top to the bottom
Outer diameter is greater than the maximum cut‐
ting depth
Plan first, then cut. Several cuts are needed –
correct sequence is important.
► Always start at the bottom, using the upper
quarter of the abrasive cutting wheel for cut‐
ting
► Use the upper quarter of the abrasive cutting
wheel for cutting the opposite lower side.
5 Sample Applications
0458-707-9821-C