Metrohm 795 KFT Titrino Gebrauchsanweisung Seite 82

3.2 Remote control commands
78
Reports which are sent from the Titrino are marked with space (ASCII 32) and
' at the beginning. Then an individual identifier for each report follows. Reports
which are triggered by RS232 ($G) have the same introducer but without pre-
ceding space, i.e. they start with '.
3.2.2.61. Info.Checksums
Info.Checksums.MPList
Info.Checksums.ActualMethod
The checksums can be used to identify the content of a file unequivocally,
e.g. files with identical content
have identical results of the checksums. An empty file has checksum "0". The
calculation of the checksums is triggered with $G.
.MPList: Result of the checksum of the current measuring point list.
.ActualMethod: Result of the checksum of the current method in the working
memory. Identical methods with different method names have the
same results of the checksum.
3.2.2.62. Info.DetermData
Info.DetermData.Write
Info.DetermData.MPList.1.Attribute
Info.DetermData.ExV
Info.DetermData.MPList.1.X
Info.DetermData.MPList.1.Y
Info.DetermData.MPList.1.Z1
Info.DetermData.MPList.1.Z2
for every measuring point
Determination data in hexadecimal format. A measuring point list is available.
Recalculation of the measuring data is triggered with $G.
.Write: With "ON", the following nodes can be overwritten:
&Info.DetermData.MP.List, &Info.TitrResults.Var.C4X (X = 0...5),
and &Mode.Name.
.ExV: Volume of the exchange unit, with which the determination was
executed
.MPList.1.Attribute: Attribute
.MPList.X: X coordinate, time
.MPList.Y: Y coordinate, volume
.MPList.Z1: Z1 coordinate, measuring value
.MPList.Z2: without meaning
$G
read only
read only
$G
ON, OFF
read only/read+write
read only/read+write
read only/read+write
read only/read+write
read only/read+write
read only/read+write
795 KFT Titrino