Care And Maintenance - TFA VIEW Bedienungsanleitung

If two probes are connected, you can use the + button to
y
choose between displaying both probes and displaying the
time in combination with the currently highest temperature.
If none of the probes are connected, only the time is
y
displayed.
Automatic switch-off and backlight
Press any button to activate the backlight for 10 seconds.
y
y If no probe is plugged in, the device switches off
automatically after 10 minutes.
y If one or two probes are plugged in, but the temperature on
both probes is below
37.7°C (100°F), the device will switch off automatically
after 60 minutes.
Installation
Probe support with cable wrap
y The probes can be attached to the probe holder for storage.
y The cable can be safely stowed away with the cable wrap.
y The sensor holder can be placed on the device and also
serves as a display protection, as shown in the illustration
(Fig. 2).
The probe holders themselves can be stacked on top of each
y
other for storage.
Connection with TFA VIEW Wifi weather station and
VIEW APP
If you own a TFA VIEW WiFi weather station, you can connect
y
the BBQ thermometer transmitter to the VIEW App to read the
measured values and set alarms on your mobile device. De-
pending on the model, there is also the option of displaying
the measured values of the transmitter directly on the base
station.
Take the base station into operation according to the instruc-
y
tion manual of the base station or proceed according to "Add
additional transmitters" in the Quick set-up guide.
y
The transmission icon is displayed when the probe is plugged
y
in and the transmitter is connected to the VIEW app. It
flashes twice with each transmission.
Note: The BBQ thermometer works without being connect-
y
ed to the VIEW app.

Care and maintenance

Clean the instrument and the probes with a soft damp
y
cloth. Do not use solvents or scouring agents. Protect it from
moisture!
Should water or steam enter the device's jack, it could affect
y
the contact with the probe.
Dry the probe connector before connecting it to your ther-
mometer.
Remove the batteries if the device will not be used for an
y
extended period of time. Place the rubber protective caps on
the openings.
Battery replacement
As soon as the battery symbol appears in the display, the
y
corresponding battery symbol in the display of the weather
station or in the device information of the VIEW App, please
change the batteries of the BBQ sensor.