8�4 Grinding Table Replacement / Cleaning; 8�5 Switch Cover Replacement; Spare Parts - Renfert MT plus Original Bedienungsanleitung

8.2 Flange Replacement / Cleaning
1� Remove the disc (refer to Section 8�1, steps 1 - 7)�
2� Have the pulling screw and Allen key at hand >>> see tool kit enclosed (Fig� 32)�
3. Screw the pulling screw into the flange (Fig. 33) >>> The flange may not be removed by hand.
Always use the pulling screw to remove the flange!
4. Remove the flange (Fig. 34).
5. Remove the pulling screw from the flange.
6. Clean the flange and the inside of the housing >>> Do not damage the seals!
Recommended for cleaning: >>> see: Accessories
7� Lightly coat the motor shaft and seal with Vaseline�
8. Replace the flange >>> Note the engagement groove (Fig� 35)�
9. Replace the flange by hand on the shaft (Fig. 36).
10� Reinstall the grinding disc (refer to Section 8�1, steps 9 - 16)�
8.3 Spray Tube Replacement / Cleaning (Wet Trimmer)
1� Remove the rinse tube (refer to Section 8�1, steps 1 - 5)�
2� Remove the gaskets (Fig� 37)�
3� Allow the rinse tube to soak in decalcifying agent overnight (Fig� 38)�
4� Reinstall the gaskets and coat them lightly with Vaseline (Fig� 37)�
5� Replace the rinse tube (Fig� 12)�
6� Close the front cover (Fig� 11)�
7� If necessary, open the water supply (Fig� 6a)�
8� Plug the power cord into the wall outlet (Fig� 7 or 14)�
8.4 Grinding Table Replacement / Cleaning
1� Switch the unit off (Fig� 8)�
2� Disconnect the unit from the power supply (Fig� 7 or 14)�
3� Open the front cover (Fig� 11)�
Do not remove the grinding table if the front cover is closed otherwise the trimmer disc will be
damaged!
4. Unlatch and remove the grinding table (Fig. 39 + 40).
5� Remove the front cover (Fig� 23)�
6� Clean the grinding table and front cover wit a brush under running water (Fig� 24)�
7. Replace and close the front cover (Fig. 23 + 11).
8� Reinstall the grinding table (Fig� 40)�
Make sure the retainers are completely free of all plaster residue! Make sure the work table is
properly seated on the front cover!
9� Plug the power cord into the wall outlet (Fig� 7 or 14)�
8.5 Switch Cover Replacement
1� Loosen the fastening screws (Fig� 41)�
2� Remove the switch cover and replace it with a new one (Art� No� 90003-5788)�
3� Retighten the fastening screws�
The MTplus may not be operated with a defective switch cover!
8.6

Spare Parts

You can find components subject to wear and the spare parts on the spare part
list in the internet at www.renfert.com/p918�
The components excluded from the warranty (such as consumables or parts sub-
ject to wear and tear) are marked on the spare part list�
Serial number and date of manufacturing are shown on the type plate of the unit�
- 7 -
en