Care And Maintenance; Accessories - Metabo FP 18 LTX Originalbetriebsanleitung

en ENGLISH
6.6 Filling the grease reservoir
ATTENTION – Fill the grease reservoir (14)
using only non-corrosive lubricants that are
approved for use in grease guns. Read the
instructions provided by the lubricant
manufacturer.
Note:
If using new grease, discharge the old grease until
the new grease is visible.
1. Filling the gun with a cartridge
400 g (TV 00) / 450 g (TV 19)
1. Unscrew the grease container (14) anti-
clockwise to release and remove it from the
device.
2. Pull out the plunger rod (23) and lock at the
plunger rod catch (24) (see p. 2 fig. B).
WARNING – The bar handle must be firmly
engaged to prevent uncontrolled loosening.
3. Remove the plastic caps from the grease
cartridge and insert the cartridge into the
grease container (14).
4. Screw the grease reservoir (14) back in place in
a clockwise direction.
5. Loosen the plunger rod (23) and press in.
2. Filling the gun from bulk containers
1. Unscrew the grease reservoir (14), turning it
anti-clockwise to release.
2. Immerse the grease reservoir (14)
approximately 5 cm in the grease and slowly
pull back the plunger rod (8) as far as it will go.
3. Secure the plunger rod (23)
4. Screw the grease reservoir (14) back in place in
a clockwise direction.
5. Loosen the plunger rod (23) and press in.
12
Release excess air in the grease reservoir by
pressing in the venting valve (2) several times
until no more air escapes.
3. Filling the grease gun with a filler pump
1. Withdraw the plunger rod (23) as far as it will
go.
2. Connect the filler neck (1) to the filler pump.
3. Switch on the filler pump and fill the grease
reservoir (14) completely.
4. Disconnect the filler neck (1) from the filler
pump.
5. Loosen the plunger rod (23) and press in.
Release excess air in the grease reservoir by
pressing in the venting valve (2) several times
until no more air escapes.
4. Filling with screw-in cartridge (only TV 00)
1. Remove the grease container.
2. Cap (32) a.d. Loosen and remove the wings (33) .
3. Screw in the thread adapter (30) and tighten it
with a suitable tool.
(see Section 9.4)
4. Screw the cartridge onto the thread adapter.
.

7. Care and Maintenance

Danger! Repair and maintenance work other
than described in this section should only be
carried out by qualified specialists .
- Check that all screw fittings are seated securely,
and tighten if necessary.
- Avoid contact with dangerous substances that
have collected on the tool. Wear suitable personal
protective equipment and take appropriate
measures to remove any dangerous substances
before maintenance.
f

8. Accessories

Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Chargers: ASC 55, ASC 145, etc.