Troubleshooting; Health And Safety At Work; Servicing And Lubrication - Tractel Corso Cleantech Installations-, Gebrauchs- Und Wartungsanleitung

Any damage to the Corso™ trolley, in particular on the
running wheels and the side plates, must be repaired by
an approved engineer before it is used again.
It is also essential to regularly check the condition of the
traversing beam and if necessary clean it to prevent the
accumulation of grease or dust which could prevent the
trolley from moving correctly.

6. Troubleshooting

If the trolley does not move smoothly and freely along
the traversing beam:
• Check that there is no obstacle on the traversing
beam.
• Check that the running wheels run smoothly and
correctly.
• Check that the running wheel pins are not damaged.
• Check that the spacing of the trolley is correctly
adjusted in relation to the width of the traversing beam.
• Check that the curved radius of the traversing beam is
not smaller than the technical capacities of the trolley
used.
• Check that any curve is not distorted or twisted at any
point.
• Check the good surface condition of the lower flange
of the beam.

7. Health and safety at work

It is the responsibility of every company to ensure that
its employees have been fully and properly trained in
the safe operation of the equipment.
Before using the equipment, check that all the safety
devices are in place and operate correctly (section
VI-5).
It is recommended that Corso™ Cleantech trolleys
must have an initial inspection on first installation and
subsequent periodic inspection. Check local regulations
and requirements.

8. Servicing and lubrication

Checks
Check general
condition of trolley
Visual inspection of
side plates and wheels
(cracks, distortion)
Visual check of running
wheels for wear and
condition
Check condition of
traversing beam
General inspection of
parts of the trolley for
wear
Frequency Person
Daily Operator
Quarterly Operator
Six Operator
monthly
Six Operator
monthly
Annually After sales
service
centre
7
EN