cecotec Rock'nCut Bedienungsanleitung Seite 8

Make sure the disc is properly fixed before operating the
machine.
To push food against the cutting disc, use the food pusher
supplied with this appliance only.
Do not touch the rotating cutting disc.
The blade of this appliance is extremely sharp; always be very
careful when operating or cleaning the appliance.
Never cut food only by using your hands. Always use the slide
and its food guide unless it is impossible because of the size
and dimension of the article. Make sure never to touch the
blade. If food gets stuck on the cutting disc, remove it with a
plastic spatula. Turn the appliance off and disconnect it from
the power supply before cleaning it.
Do not insert fingers or any other items such as knives, forks
etc. into the area between the cutting thickness-setting plate
and the cutting disc.
Make sure the cutting disc has completely stopped before
removing food.
Do not let cord hang over edge of table or counter.
A short power supply cord is provided to reduce the hazards
resulting from becoming entangled in or tripping over a longer
cord.
Extension cords may be used if care is exercised in their use.
Always turn off and disconnect the appliance from the power
supply before assembling, disassembling it or if it is not going
to be used for a long period of time. Pull from the plug and not
the cord to disconnect it.
It is absolutely necessary to keep this appliance clean at all
times as it comes into direct contact with food.
The appliance is not intended to be used by children, persons
with reduced physical, sensory or mental capabilities or lack of
experience and knowledge.
Note: Never use the slicer for more than 10 minutes continuously.
08021_Rock'nCut_Manual_YV_01200813.indd 8 08021_Rock'nCut_Manual_YV_01200813.indd 8 19/8/20 7:36 19/8/20 7:36