Intended Use; Identification Plate; Operating Controls; Using For The First Time - Wolf Garten GS 10 eM Originalbetriebsanleitung

Safety information
General safety instructions
¾ Spare parts must meet the requirements of
the manufacturer. Therefore, use only original
spare parts or those spare parts authorised by
the manufacturer. When replacing spare parts,
always observe the supplied fitting instructions.
Remove the operating arm in which the power
pack is permanently installed beforehand.
¾ Repairs must only be performed by a quali-
fied expert or workshop. Specialist workshop
addresses can be found on our website.
¾ These grass shears are intended for lawn
maintenance in private gardens. The device
must not be used for purposes other than those
intended because of the risk of bodily injury to the
user or other persons.

Intended use

The grass shears are intended solely for maintaining
lawn edges and small lawn areas in private gardens.
Any other use is classed as an unintended use.
The user is liable for any damages arising from
unintended use.

Identification plate

Position
The identification plate is located on the casing of
the device.
Structure G
1 Manufacturer
2 Device group
3 Model name
4 Rated voltage, current type
5 Weight
6 IP code
7 Disposal note
8 Year of manufacture
9 Guaranteed sound level
10 CE label
11 Model number
12 Serial number
Safety information
¾ Even if all safety and operating instructions
are heeded, there is always a residual risk of
injury and property damage. Always be con-
scious of this!
¾ Do not use the device if it is raining or there is
a risk of storms.
¾ Replace all worn or damaged information
signs on the device.
¾ Only use the power packs/operating arms
with permanently installed power packs as
approved by the manufacturer together with
the corresponding chargers. The designations
of the approved power packs/operating arms with
permanently installed power packs and char-
gers are listed in the enclosed CE Declaration of
Conformity.
Operating elements H
1 Lock-on switch
2 On/off switch on handle
3 Handle
4 Holding area for the hand / fastening area for the optional
middle handle
5 Operating arm *(with permanently installed power pack)
6 Locking button
7 Cutting blade
8 Protective cover
9 Wheels
10 Working angle adjustment locating button
*Necessary operating element (not supplied)
Supplementary documentation
Ensure the supplied instruction man-
uals of the charger and operating arm
are available and that you have read
and understood them before using the
device.
Power pack charging
Only charge the power pack using the
charger approved by the manufacturer.
The designations of the approved chargers
are listed in the enclosed CE Declaration of
Conformity.

Operating controls

Using for the first time

WARNING!
EN
21