Herunterladen Inhalt Inhalt Diese Seite drucken

cecotec Conga 1990 Connected Bedienungsanleitung Seite 49

Vorschau ausblenden Andere Handbücher für Conga 1990 Connected:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 65
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested
to replace them either after a maximum of 160 hours of use or when they are worn out due to
operation.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. You can also use warm water without detergents to obtain better results.
Always make sure they are completely dry before installing them again.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to clean thoroughly edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours.
Recommendation
It is recommended to clean the side brushes once a week with the help of the cleaning brush.
Main brush
The main brush is designed with bristles and silicone, spins at top speed and helps introduce
dirt into the suction nozzle. This brush is in contact with the floor, and therefore with dirt, so it
can be worn out over time, affecting negatively to the cleaning efficiency. For this reason, it is
suggested to replace each side brush after a maximum of 320 hours.
Recommendation
It is recommended to clean the main brush once a week with the help of the cleaning brush.
Sensors
Cleaning robot vacuum cleaners have different types of sensors, for example, proximity
sensors that allow the robot to move around while detecting obstacles or free-fall sensors
that help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can be blocked over time,
causing possible navigation errors. It is suggested to clean all the robot's sensors with the
cleaning brush or with a dry cloth after a maximum of 35 hours of operation.
Battery charge and replacement
-
To lengthen the battery's service life, keep the robot charging on the charging base when
not in use.
-
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
-
To replace the battery, follow the instructions below:
05660_Conga 1990 Connected_IM_YV_0121085.indd 49
05660_Conga 1990 Connected_IM_YV_0121085.indd 49
ENGLISH
49
6/8/21 13:08
6/8/21 13:08

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

05660

Inhaltsverzeichnis