match with those of the charging base. Once the robot is properly placed, it will beep once
and the power button will light up. If the light blinks orange, it means the battery is not
completely charged. To ensure maximum cleaning time, wait until the light switches to
steady blue. This will indicate the battery is fully charged and that the robot is ready to
clean. Fig. 25
3. OPERATION
Start cleaning
Hold down the power button on the robot to activate the robot up.
Press the power button on the robot or on the remote control to start cleaning.
Note
If the robot runs out of battery during cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
Warning
If there is no good access to the charging base, the robot will not be able to return to its charging
position. In that case, once the robot has stopped, take it manually to the charging base.
Pause
Press the power button on the robot or on the remote control to pause the cleaning process.
Press the power button on the robot or on the remote control to resume the cleaning process.
Fig. 26
Return to the charging base
Press the back home button on the robot or on the remote control in order to send the robot
to the charging base.
Turn off
Hold down the power button to turn the robot off. Fig. 27
Warning
The robot vacuum cleaner has a power switch located on its main body. If the robot is not
going to be used for long periods of time, it is suggested to switch it off. If the robot is switched
off, it will restore factory default settings as a safety measure. The robot will only carry out
scheduled cleaning if it has been scheduled while the switch is ON. Otherwise, it will have to
be scheduled again from the remote control or the App.
05660_Conga 1990 Connected_IM_YV_0121085.indd 45
05660_Conga 1990 Connected_IM_YV_0121085.indd 45
ENGLISH
45
6/8/21 13:08
6/8/21 13:08