Possible Cause - Silverline 264125 Bedienungsanleitung

GB
Troubleshooting
Problem

Possible cause

Solution
No power Check power supply
No function when ON/OFF Trigger Switch
(1) is operated
Defective ON/OFF Trigger Switch Have the ON/OFF Trigger Switch replaced by an authorised Silverline service centre
Slow material removal Sanding Sheet (8) too fine or worn Fit new Sanding Sheet with coarser grit
Sanding Sheet too coarse Fit new Sanding Sheet with finer grit
Scratches on workpiece after sanding
Not enough material removed Continue sanding
Sanding Sheet incompatible with material Fit correct Sanding Sheet
Burn marks on workpiece
Too much pressure exerted on to the sander Use less pressure whilst moving the tool
Dust extraction not working; Sanding Sheet not aligned with dust
Excessive dust emission Realign Sanding Sheet; unblock dust extraction holes
extraction holes in the Sanding Base (3); extraction holes blocked
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
10