Possible Cause - Silverline 521333 Bedienungsanleitung

EN
Troubleshooting
Problem
No function when ON/OFF Trigger
Switch (3) is operated
Slow material removal
Scratches on workpiece
after sanding
Burn marks on workpiece
Excessive dust emission
EN
521333_OwnerManual.indd 10 521333_OwnerManual.indd 10

Possible cause

No power
Defective ON/OFF Trigger Switch
Sanding sheet (8) too fine or worn
Sanding sheet too coarse
Not enough material removed
Sanding sheet incompatible with material
Too much pressure exerted on to the sander
Dust extraction not working; sanding sheet not aligned
with dust extraction holes in the Sanding Base Plate (10);
extraction holes blocked
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Solution
Check power supply
Have the ON/OFF Trigger Switch replaced by an authorised Silverline service
centre
Fit new sanding sheet with coarser grit
Fit new sanding sheet with finer grit
Continue sanding
Fit correct sanding sheet
Use less pressure whilst moving the tool
Realign sanding sheet; unblock dust extraction holes
23/08/2021 13:03 23/08/2021 13:03