GYS GYSPOT COMBI 230 E PRO Bedienungsanleitung Seite 17

Translation of the original instructions
- Grind the area which needs to be straightened, such that the 3 brass pads can make the ground contact with the
aluminium car body.
- Position the stud in the copper tip of the gun. Adjust if necessary the screw adjustment of bumper stud (see pictures
below)
- In order to get a good welding of the stud, the base must come out by approximately 1mm from the extremity of the
mandrel (6)
- The position of the stud in the mandrel can be adjusted by screwing / unscrewing the nut on the adjustment screw (4)
Upon delivery of the gun, the screw (7) is loosened and the cursor (8) is in abutment. This setting allows exerting a
force of about 20 N during welding, which is suitable for welding aluminium studs M4. The screw is used to adjust the
down force of the spring when the shot is fired or to compensate for the wear of the spring.
Adjust the power or the voltage value using + and - buttons. At power up the power value by default is 5 which is 100
volts. In general, the value to have a good welding of a M4 stud for small dent removal is: voltage = 90 V or power = 4.
Increase the voltage for thicker panels. Be careful, too elevated power can damage the copper base.
For a good weld, only the « nipple of the stud » must be in contact with the component.
Make a small pressure on the gun without crushing the "pin" of the stud. The capacitor discharge is done automatically
when the support comes in the ring.
At this moment the stud is correctly welded. Welding duration is less than 3 milliseconds.
For an optimum repair, we advise you to warm up the metal sheet.
6
The copper base has 4 slots and is dedi-
cated to M4 studs
Screw for adjusting the stud's position.
4
The pin must be perpendicular to the sheet.
5
Do not press too much to not overwrite the nipple. Only the stud is in contact with the sheet.
The base must come out by approximately 1mm from the extremity of the mandrel.
6
A wheel with index
8
7
THERMAL PROTECTION
The machine is provided with an automatic thermal protection system, which will stop the machine to prevent it from
overheating. When the Thermal Protection Indicator illuminates (fig.I-5 - II-5), let the machine cool down.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSPOT COMBI 230 E PRO
4
allows adjusting the compression of the spring.
5
Automatic gun without trigger
EN
8
7
17