BOMANN GSP 7408 Bedienungsanleitung, Garantie Seite 28

leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, www.bomann-germarny.de. To order, use the
reference number found under
Connecting the water inlet hose
(cold water connection)
NOTE:
The water pressure must be between 0.04-1.0 MPa.
For higher water pressure: connect pressure reduc-
ing valve upstream.
• Connect the water inlet hose to a
water thread with ¾". Tighten the
hose in the direction of the screw
thread; make sure it is firmly
seated.
• Connect the other end of the inlet
hose to the inlet valve on the rear
of the appliance; also ensure that
it is firmly seated.
Connecting the water drain hose
NOTE:
The water drain hose is approx. 1.5 m long and can
be extended to max. 4 m with a suitable hose and
connector.
CAUTION:
To prevent dirty water from flowing back, the free end
of the hose must not be below the water level of the
drain.
"Technical data"
.
• Connect the drain hose to a drainpipe (B) with a
minimum diameter of 40 mm; alternatively, the
hose can be attached to a sink or directly to the
drain (A).
• In any case, make sure that the drain hose is not
bent or squeezed.
• The drain hose may be installed up to a maximum
height of 1000 mm above the rinsing floor.
• Fasten the hose securely to prevent it from
changing its position and thus leaking water.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not use multiple sockets or extension cords.
• It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
• The accessibility of the power plug must always
be ensured to disconnect the appliance from the
power supply in case of an emergency.
• Make sure that the voltage supply matches the
specifications on the rating label (door frame) be-
fore connecting.
• Connect the mains cable to a properly installed
and earthed wall outlet.
28