Before Use; Selecting A Sanding Sheet; Changing Sanding Sheets; Dust/Chip Extraction - Parkside PEXS 270 C3 Originalbetriebsanleitung

Before use

Selecting a sanding sheet

Removal and surface
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet.
■ Please note that you need to use sandpapers
with different grains for working different
materials.

Changing sanding sheets

The random orbital sander has a Velcro sheet that
enables fast and simple changing of the sanding
sheets.
♦ Life the sanding sheet 4 on one side and pull
it off the sanding pad 3 to remove it.
NOTE
► Before fitting a new sanding sheet 4, remove
any dust and dirt from the sanding pad 3.
♦ Make sure that the holes on the sanding sheet 4
match up with the holes on the sanding pad 3.

Dust/chip extraction

■ Please refer to the section entitled "Safety
information".
Self-extraction with dust collector
Connection
♦ Push the dust collector 2 onto the appliance.
Turn the dust collector 2 towards the
bol to lock it.
Removal
♦ Turn the dust collector 2 towards the
Pull the dust collector 2 off the appliance (see
detailed illustration on fold-out page).
NOTE
► To ensure optimum extraction, empty the dust
collector 2 regularly.
■ 6 │ GB │ IE
♦ To do this, remove the dust collector 2 from the
appliance as described above. To do this, open
the dust collector 2 by pressing on the release
button 8 and pulling off the rear part (see
detailed illustration on fold-out page). Now
remove the dust bag. Clean the dust bag
thoroughly by tapping it out.
External extraction
Connecting
♦ To remove dust using a vacuum cleaner, push
the suction hose of a suitable dust extraction
device (e.g. a workshop vacuum cleaner) onto
the exhaust nozzle 6.
NOTE
► If necessary, use the adapter 7 by pushing it
into the exhaust nozzle 6.
Removal
♦ Pull the hose of the vacuum cleaner off the
exhaust nozzle 6 or the adapter 7.

Use

Switching on and off
NOTE
► Always switch on the random orbital sander
before making contact with the material, then
apply it to the workpiece.
Switching on
♦ Press the ON/OFF switch 1.
sym-
Switching off
♦ Release the ON/OFF switch 1.
symbol.
Speed preselection
♦ Select the required speed with the speed
control 5.
Level 1: low speed
Level 6: high speed
PEXS 270 C3