Wohler DC 100PRO Bedienungsanleitung Seite 71

8. Setupmenu Wöhler DC 100
PRO
12. Setup —> Humidity —> Slope
Here you enter the calibration value Slope for the humidity sensor. An exa-
mple slope of 31.31 mV is shown in Figure 3.6 under Section 3.5. The value
taken from the calibration sheet must be rounded to two decimal places
(25.00–60.00 mV, default 31.31 V).
13. Setup —> Log rate
Here you can set the time between two registrations by the logger. The de-
fault is thirty seconds; in other words, the pressure, two temperatures, and
the humidity are each measured and the values written to the integrated data
memory every thirty seconds (see Section 9.2; default 30 s).
14. Setup —> AUTO OFF
This activates and deactivates the AUTO OFF function. This serves to switch
OFF the device automatically when no key has been pressed for longer than
thirty minutes (default ON).
15. Setup —> IrDA
This activates the continuous IrDA data transfer. In this case all four mea-
sured values (pressure, 2 x temperature, relative humidity) and their corre-
sponding channel numbers are transferred to a PC every second during the
normal measuring process (default OFF).
16. Setup —>Quickprinter
The default in the puickprinter-mode is „ON". In this mode, you can print the
dates with the Wöhler TD 600/610 termoprinter. If you enter „OFF", you can
print with another printer (GP, TD 23 etc.)
17. Setup —> Logo
Here you can enter the logo text for printouts. This is explained under the
following Section 8.2 (default WÖHLER MGKG, DC 100 ).
PRO
18. Setup —> Default
This function restores the device's setup status on delivery. The logo text is
overwritten by the original Wöhler logo. All sensor calibration values remain
unchanged, except the humidity sensor . Accidental initiation is prevented by
the prompt Sure?.
71
e-Mail: mgkg@woehler.com http://www.woehler.com