Assembly Instructions - Christopeit Sport EMT2400 Montage- Und Bedienungsanleitung

ASSEMBLY INSTRUCTIONS

Remove all the separate parts from the packaging,
lay them on the floo and check roughly that all are
there on the base of the assembly steps. Please note
that a number of parts are connected directly to the
main frame preassembled. In addition, there are sev-
eral other individual parts that have been attached to
separate units. This will makes assembly easier and
quicker for you. Assembly time: 30 - 40 min.
STEP 1:
Attach the front and rear stabilizer (68+85) to main
frame (71).
1. Attach the front stabilizer (85) assembled with
end caps with transportation rollers (84) to main
frame (71), using carriage bolts M8x60 (70), curved
washers (69) and spring washers (6).
2. Attach the rear stabilizer (68) assembled with
end caps with height adjustment (67) to main frame
(71), using bolts M8x60 (70), curved washers (69)
and spring washers (6). (For uneven floor you can ad-
just the height with wheel at end cap (67).)
STEP 2:
Attach the pedals (42L+42R) to pedal cranks
(41L+41R).
1. Attach the pedal straps to the corresponding
pedals (42R+42L). The pedal and pedal straps are
marked with „R" for right and „L" for left.
2. Connect each pedal (42R+42L) to the match-
ing pedal crank (41L+41R). (Note: Right and Left are
specified as viewed seated on the machine during
training and the right pedal „R" should be threaded
on clockwise. The left pedal „L" should be threaded
on counter-clockwise.)
STEP 3:
Attach the saddle (25) and saddle support (20) to
main frame (71).
1. Insert the saddle support (20) into the provid-
ed holder of the main frame (71) and secure at the
desired position by screwing in the rapid action lock
(18). (Note: To screw in the rapid-action lock (18),
the threaded hole in the main frame (71) and one of
the holes in the saddle support (20) must be aligned.
Furthermore, ensure that the saddle support (20) is
not pulled out of the main frame beyond the marked
maximum position. The setting of the saddle post
can be adjusted as desired later. For this, the rapid
action catch (18) must be loosened by only 1-2 revo-
lutions, the cap of the lock must be pulled away and
the saddle adjusted. Then secure the new setting by
tightening the rapid action catch.)
2. Put the saddle (25) with saddle bracket into the
movable saddle slide (24) and tight it up in desired
incline position. Then secure the position of saddle
slide (24) with hand grip screw (29) at saddle support
(20).
15
GB