Dust/Chip Extraction; Starting Operation - Bosch 1 609 92A 4XS AS Originalbetriebsanleitung

► Use only the chargers listed on the
accessories page. Only these chargers are
matched to the lithium-ion bat tery of your
power tool.
Note: The battery is supplied partially charged.
To ensure full battery capacity, fully charge the
battery in the charger before using your power
tool for the first time. The lithium-ion battery can
be charged at any time without reducing its
service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep
discharge by the "Electronic Cell Protection
(ECP)". When the battery is discharged, the
power tool is switched off by means of a
protective circuit: The application tool no longer
rotates. Do not continue to press the On/Off
►
switch after the power tool has automatically
switched off. The battery can be damaged.
Removing the battery
To remove the battery (6), press the battery
Bosch Power Tools 1 609 92A 4XS | (22.02.2019)
14 | English
Firmly tighten the sleeve of the keyless chuck (2)
by turning it by hand in the rotational direction ➋
until it stops clicking. This will automatically lock
the drill chuck.

Dust/Chip Extraction

Dust from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dust can cause allergic reactions
and/or lead to respiratory infections of the user or
bystanders.
Certain dust, such as oak or beech dust, is
considered carci nogenic, especially in connection
with wood-treatment ad ditives (chromate, wood
preservative). Materials containing asbestos may
only be worked by specialists.
– Provide for good ventilation of the working
place. – It is recommended to wear a P2
filter-class respirator. Observe the relevant
regulations in your country for the ma terials to be
worked.
► Avoid dust accumulation at the workplace.
Dust can easily ignite.
release but ton (5) and pull the battery to the rear
and out of the power tool. Do not use force to do
this.
Changing the tool (see figure A)
The drill spindle is locked when the on/off switch
(8) is not pressed. This makes it possible to
change the application tool in the drill chuck
quickly, conveniently and easily. Open the
keyless chuck (2) by turning it in the direction of
rotation ➊ until the tool can be inserted. Insert
the tool.
Operation

Starting Operation

Inserting the battery
Note: The use of batteries unsuitable for your
power tool can lead to malfunctions or damage to
the power tool. Set the rotational direction switch
(7) to the middle position to avoid unintentionally
switching it on. Insert the charged battery (6) into
the handle until you feel it engage and it is flush
with the handle.
Setting the rotational direction (see figure B)
The rotational direction switch (7) is used to
change the ro tational direction of the power tool.
However, this is not pos sible while the on/off
switch (8) is being pressed. Right rotation: To drill
and to drive in screws, press the ro tational
direction switch (7) through to the left stop. Left
Rotation: To loosen and unscrew screws and
nuts, press the rotational direction switch (7)
through to the right stop.
Switching on/off