SOMFY Sunea 40 Solar io Anleitung Seite 12

EN
1] Position the motorised product at the mid-height position.
2] To activate the "Closing force" function, make two successive presses:
• Firstly, press the my and Up buttons briefly and simultaneously, with no
moving of the motorised product.
• Secondly, press and hold the my and Up buttons simultaneously, until the
motorised product moves up and down.
ð The drive is now in programming mode for only 10 seconds. By default,
the drive is factory set at the medium level.
3] To increase the closing force, press the Up button until the motorised
product makes a slow movement:
ð The cassette's closing force has moved up a level.
4] To decrease the closing force, press the Down button until the motorised
product makes a slow movement:
ð The cassette's closing force has moved down a level.
5] To confirm the new setting, press the my button until the motorised product
moves up and down.
g The new value for the "Closing force" function is recorded.
2.3.8.Adding/Deleting sensors
1] To add or delete a sensor, press and hold the PROG button on the
programmed control point until the motorised product briefly moves up and
down.
2] Briefly press the PROG button on the sensor to be added/deleted: the
motorised product briefly moves up and down.
g The sensor is added/deleted.
NOTICE
If the sensor on an installation is changed or deleted, it is important to delete it from the memory of all the drives in
which it was programmed: perform step 1 with a programmed control point, then perform step 2 with the sensor to
be deleted.
NOTICE
For information about the compatibility of the drive with the motorised product and accessories, contact the product
manufacturer or Somfy.
12
1]
3]
5]
1]
2 s
PROG.
2]
0.5 s
PROG.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Sunea 40 Solar io
2]
0.5 s
4]