Christopeit Sport RS 100 Montage- Und Bedienungsanleitung Seite 17

Cleaning, Checks and Storage of the home bike:
1. Cleaning
Use only a less wet cloth for cleaning.
Caution: Never use benzene, thinner or other aggressive cleaning
agents for surface cleaning as this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Remove the batteries from the computer while intending the unit for
more than 4 weeks not to use. Push the seat toward the handgrip.
Choose a dry storage in-house and put some spray oil to the pedal
bearings left and right, and on the thread of the handgripscrew for
saddle support.
Cover the bike to protect it from being discolor by any sunlight and
dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections
for tightness, which were prepared in the assembly. Every 100
operating hours, you should put some spray oil at the pedal
bearings left and right, and to the thread of gripscrew for seat.
Troubleshooting
If you cannot solve the problem with the following information, please
contact the authorized service center.
Problem Possible Cause
Computer No Batteries insert
has no value or batteries empty
at Display if
you press any
key.
Computer is Sensor impulse
not counting missing base on
data and do not well plugged
not switch connection
on after start
cycling.
Computer is Sensor impulse
not counting missing base on not
data and do correct position of
not switch sensor.
on after start
cycling.
Resistance Connection of resi-
don't change stance not well
17
Solution
Check the position of batteries at
battery compartment or replace
batteries.
Check the plug connections at
computer.
Take off the cover and check the
distance between magnet and
Sensor. The magnet at turning
belt wheel should have only less
than < 5mm distance against the
sensor position.
Check the resistance connection
inside the housing in regard to
well connection.