Installation; Preparing For Installation - Free2Move eSolutions eProfessional Installationshandbuch

2. INSTALLATION

WARNING: Failure to observe the instructions in this manual may cause serious
damage to both the product and the installer (in the most serious cases, injuries
may be fatal). Please read this manual carefully before installing, switching on and
using the product. Free2Move eSolutions S.p.A. recommends only using experienced
professionals who comply with current regulations to install the product correctly.
Once the device has been powered up, the LED will not blink immediately.
This can take up to one minute.
2.1.

Preparing for Installation

The entire power supply system must be prepared and calibrated in compliance with
local and international standards in force, according to the product configuration and
chosen power rating.
Before choosing and installing the device, the installer must consider local restrictions as set out
in the IEC 61851-1 standard. However, it remains the responsibility of the installer to check that
these regulations are still in effect, and above all to verify whether additional local regulations
apply and could restrict use of these devices in the country of destination.
Installation must comply with IEC 60364-7-722 standard
Installation and start-up of the device should only be carried out by qualified personnel who are
able to identify hazards and act safely.
12