Installation - Hozelock Saturn Booster Installationsanleitung

GB
only
DESCRIPTION
SAFETY AND ELECTRICAL
CONNECTIONS
• Always disconnect the electricity supply
before starting to handle, maintain,
repair or install any pond equipment.
• This product is not submersible, and
should be sited where it cannot fall into
the water or become waterlogged.
However, the design is weatherproof,
and the Saturn Booster can be safely
installed outdoors.
• This product is supplied with 10m of 3
core electric cable for connection to the
mains supply. The termination to the
mains supply should be permanent,
inside a dry, weatherproof enclosure,
through a double pole switched fused
spur with a minimum contact gap of
3mm – '(disconnector) to BS 3676' – and
fitted with a 3 amp fuse.
THIS APPLIANCE MUST BE EARTHED
•
AND IT IS ESSENTIAL THAT THE
CONNECTIONS ARE MADE USING THE
FOLLOWING CODE;
The BROWN lead should be connected
to the LIVE terminal which may be
marked with an 'L' or coloured brown
Australia & NZ
or red. The BLUE lead should be
connected to the NEUTRAL terminal
which may be marked with an 'N' or
coloured blue or black. The
GREEN/YELLOW lead should be
connected to the EARTH terminal
which may be marked with an 'E' or
coloured green or green/yellow.
• Exposed cable runs should be sensibly
positioned and protected if necessary by
armoured conduit.
• A 10mA or 30mA Residual Current Circuit
Breaker (RCD) MUST be fitted to the
mains supply.
• Permanent installations to the mains
supply (hard wiring) must comply with
the regulations of your local authority.
Contact your local authority building
control department for advice before you
start installation and they will let you
know how to get your installation
approved.
• If in any doubt about wiring to the
mains supply, consult a qualified
electrician or your local authority.
• The pump is fitted with 10m of 3 core
electric cable which is permanently
connected and sealed to the motor.
The supply pump cable cannot be
replaced. If the cable is damaged, the
pump should be removed and discarded
and replaced with a new pump.
• Protect from frost if the unit is not run
year round, by draining and removing to
a store in a dry, frost protected place.
• When full of water, the Saturn Booster
weighs nearly 100kg. DO NOT attempt to
move when full of water. To drain, pull
up the flush handle to empty some of
the water, and then gently tilt the
Booster until most of the water is
emptied.
IMPORTANT NOTE: The Booster is a sealed
product and can be installed below pond
level. If you plan to bury it you will have to
remove the lid and siphon or ladle the
water out to empty it (for winter storage).
Never completely bury the Booster. Ensure
the lid and valve housing are above ground
as shown in Fig. 4.

1. INSTALLATION

Important
To complete the installation you will need
two additional hoses:
1. One of 25mm, 32mm or 40mm diameter
to take the waste from the Saturn
Booster to a convenient flower bed or
drain (the 'Flush Away Hose')
2. A hose with the same diameter as your
existing pond pump hose to connect
from the filter bypass valve on the
Saturn Booster back to your pond (the
'Bypass' hose).
Assembly
Installation
Inlet and Outlet Hoses:
Flush-Away Hose: