Inhaltsverzeichnis
Werbung
■ Do not use the electric power tool if it has
a damaged power cord. Do not touch the
damaged power cord and pull out the
mains plug if the power cord is damaged
during work. Damaged power cords
increase the risk of an electric shock.
■ Use the electric power tool for dry
sanding only. If water penetrates the
electric power tool, there is an increased
risk of electric shock.
■ Dust released from materials, such as lead
paints, some types of wood, minerals and
metal, may be hazardous to the operator
or people in the vicinity. Inhaling or
touching these dusts may result in respiratory
diseases and/or allergic reactions.
– Ensure the work place is well ventilated!
– If possible, use external dust extraction.
– It is recommended to wear a respirator
mask belonging to filter class P2.
■ Secure the workpiece. A workpiece is
held more securely in a clamping device or
vice than by hand.
■ Keep the workplace clean. Material
mixtures are especially dangerous. Light
metal dust may burn or explode.
■ Do not work on materials which release
hazardous substances (e.g. asbestos).
■ Never grind or cut light metals which have
a magnesium content greater than 80%.
Risk of fire!
■ Before using the machine, check that the
grinding tools have been installed and
secured correctly. Switch on the power tool
at no load for 30 seconds!
■ Interrupt the test run immediately if
violent vibrations occur or other damage
is established. Check the machine to
determine the cause.
■ Before putting down the power tool, switch
it off and wait until it comes to a standstill.
■ Do not clamp the power tool in a vice.
■ Always lay the power cord to the rear away
from the electric power tool.
Additional safety instructions
■ Use only extension cables permitted for
outdoor use.
■ Identify the power tool with stickers only.
Do not drill any holes into the housing.
■ The mains voltage and the voltage
specifications on the rating plate must
correspond.
12
ORE 2-125 EC / OSE 2-80 EC / ODE 2-100 EC
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 62841.
The evaluated noise level of the power tool is
typically:
ORE 2-125 EC
OSE 2-80 EC
ODE 2-100 EC
Total vibration value:
ORE 2-125 EC
OSE 2-80 EC
ODE 2-100 EC
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 62841 and may be used to compare one
tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications of the
tool. However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use. This may
significantly decrease the exposure level over
the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
Sound
Sound power
pressure level
level L
L
[dB(A)]
[dB(A)]
pA
75
77
76
Uncertainty K=3dB
Emission value a
3.5
3.5
3.5
Uncertainty K=1.5 m/s
WA
86
88
87
(m/s
2
)
h
2
Werbung
Inhaltsverzeichnis
