Light Mode - Makita TD003G Betriebsanleitung

Light mode

You can use the tool as a handy light.
Turning on / off the light mode
To turn on the light, set the reversing switch lever in the
neutral position and pull the switch trigger.
The lamp keeps lighting up for approximately one hour.
To turn off the light mode, pull the switch trigger again or
depress the reversing switch lever.
NOTE: You cannot change the application mode
while the light mode is on. The lamps on the switch
panel do not turn on when the light mode is on.
NOTE: You cannot turn on/off the lamp status or
change the application mode when the light mode is
on.
NOTE: The light mode does not work when the tool/
battery protection system activates or the battery
capacity is not enough.
Changing the impact force
You can change the impact force in five steps: 4 (max), 3 (hard), 2 (medium), 1 (soft) and T mode.
This allows a tightening suitable to the work.
"T" is a special mode for fastening self-drilling screws. This mode helps to prevent the screws from over-tightening. It
also accomplishes quick operation and good finish at the same time. The tool drives a screw with high-speed rotation
and stops soon after the tool starts to impact.
The level of impact force changes every time you press the button
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the button
button .
► Fig.8
Application mode
(Impact force grade
displayed on panel)
4 (Max)
3 (Hard)
2 (Medium)
Maximum blows
-1
4,100 min (/min) Tightening with the maximum force
and speed.
-1
3,600 min (/min) Tightening with less force and speed
than Max mode (easier to control than
Max mode).
-1
2,600 min (/min) Tightening when a good finishing is
needed.
Changing the application mode
What's the application mode?
The application mode is the variation of the driving
rotation and impact which are already preset in the tool.
By choosing a suitable application mode depending on
the work, you can accomplish quicker work and/or more
beautiful finish.
This tool features following application modes:
Impact force
• 4 (Max)
• 3 (Hard)
• 2 (Medium)
• 1 (Soft)
• T mode
The application mode can be changed by the but-
ton or button .
► Fig.7: 1. Button
NOTE: When none of the lamp on the panel is lit, pull
the switch trigger once.
NOTE: You will not be able to change the application
mode if you do not operate the tool for approximately
one minute. In this case, pull the switch trigger once
and press the button
or button
Purpose
9 ENGLISH
2. Button
or button .
.
Example of application
Driving screws to underwork materi-
als, tightening long screws or bolts.
Driving screws to underwork materi-
als, tightening bolts.
Driving screws to finishing boards or
plaster boards.
or