Care And Maintenance - Hilti TE 700-AVR Original Bedienungsanleitung

▶ Set the function selector switch to
5.6 Locking the chisel
▶ Set the function selector switch to
5.7 Setting the chiseling power
Chiseling power can be reduced to approx. 70% by pressing the power level selector switch. The
power level LED then lights up, indicating reduced power.
Chiseling power can be adjusted only when the power tool is switched on and ready for use. To
reselect full chiseling power, press the chiseling power level selector switch again. Switching off and
then on again also causes the power tool to return to full chiseling power.
▶ Press the power level selector switch.
6 Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool without
an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used, always make sure that an earth/ground
conductor and ground fault circuit interrupter are present in the power supply and that these are correctly
connected.
▶ Do not use the product unless these safety measures are in place and fully operational.
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
Full approval must be obtained from the site engineer or architect prior to beginning the work.
6.1 Chiseling 6
▶ Set the function selector switch to the
7

Care and maintenance

WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including
burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
18 English
and position the chisel as desired.
and rotate the chisel until it engages.
position.
428075
*428075*