Herunterladen Inhalt Inhalt Diese Seite drucken

Programming Mode / Handheld And Wall Transmit- Ters - Julius Mayer JM35-F Serie Montageanleitung

Rohrmotor
Vorschau ausblenden Andere Handbücher für JM35-F Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
HAND-HELD AND WALL TRANSMITTERS PROGRAMMING
Programming mode radio drive JM35-F / JM45-F
1.
Disconnect the drive from the mains (fuse OFF)
2.
Wait approx. 10 sec.
3.
Switch on the fuse again
4.
The drive beeps - the shutter moves briefly UP/DOWN
Programming - handheld or wall transmitter
Various hand-held and wall-mounted transmitters (not included in the scope of delivery of the motor) are available for controlling
the roller shutter motor. Compatible hand-held and wall transmitters can be found on page 8. Using the copy function, several
transmitters can be taught into the receiver of the JM-F motors. In this way, individual, group and central control of roller shutters
can be realized. With the help of the first learned transmitter, another (additional) transmitter is learned into the memory of the
motor. Afterwards, it is possible to program additional transmitters from each taught-in transmitter.
See page 16 "Adding manual and wall transmitters".
1.
First select the desired channel by pressing the K1 (or K2) key
(selected channel is shown in the display).
2.
Then put the receiver (motor / external receiver) into programming mode.
3.
Press the P2 programming button of the handheld or wall transmitter (back) 2 times.
4.
Press the UP key 1 x.
5.
The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps.
OK - Handheld transmitter is programmed.
To program additional channels (1-15), start from the beginning.
Engine lt.
Connect the
connection diagram
(page 13).
Fuse OFF.
Press key P2 (back)
of the handheld
transmitter 2 x.
The motor "beeps"
2 x.
Then check the function by pressing the UP / STOP / DOWN keys!
The direction of rotation of the motor must be set (programmed) correctly, as otherwise roller shutters may close instead of
opening under certain circumstances (e.g. when using hand-held or wall-mounted transmitters with timer function)!
*If the direction of rotation of the motor is reversed (roller shutter / motor moves downwards when the UP key is pressed),
please start from the beginning and press the DOWN key instead of the UP key after the P2 key!
This will change the direction of rotation of the motor.
Display - Channel display /
Function display
Keys K1 / K2
Up
Stop
Down
Fuse /
The motor
Power supply
"beeps".
ON.
Press the UP
The motor
key* of the
"beeps".
handheld
transmitter once.
(Example with JMHS-15)
Programming-
key P2
The receiver of the motor
is now in programming
standby for approx. 10
seconds.
The handheld or wall
transmitter is programmed.
The programming mode is
ended automatically.
31

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis