Iget HOME G3 HURRICANE Gebrauchsanweisung Seite 36

Installation
1. Remove the protection material from both sides of the
robot
2. Install side brushes
Put the left side brush (L) and right side brush (R) against the letters L and R
on the bottom shell respectively, press down, you will hear a "click" sound,
and it means that the side brushes are installed in place.
3. After connecting the power adapter to the power supply,
connect it to the charging base and tidy up the
redundant wires
4. Place the charging base on a flat ground against the wall
and connect to the power supply
>1.5m
Note:
· Ensure a space more than 0.5m from the left and right of the charging base and 1.5m in front of
the charging base.
· The power line perpendicular to the ground may be dragged by the main unit, and the charging base
may be powered off.
· The charging indicator light is normally on when the main unit is powered on.
6