Transportation, Storage And Disposal - Husqvarna WDC 220 Bedienungsanweisung

6. Put the motor unit on the dirt container and lock the
clasps. (Fig. 12)
To replace the filter bag
1. Stop the product, see
13 .
2. Unlock the clasps and lift off the motor unit. (Fig. 8)
3. Do a check to see if the filter bag is full. Remove the
filter bag if it is full.
4. Pull the cardboard part of the old filter bag from the
vacuum inlet.
Transportation and storage
• After use:
• Disconnect the plug from the mains when the
product is not in operation.
• Wind up the cord starting from the product.
• Use the cable holder to attach the cord on the
motor unit.
• Wind up the hose.
• Use the hose holder to attach the hose on the
motor unit.
• Transport:
• Close all clasps on the motor unit.
• Do not tilt the product if there is liquid in the dirt
container.
• Do not use a crane hook to lift the product.
• Storage:
• Keep the product in a dry and frost free area.
To recycle the product
Follow these steps to make the product unusable.
1. Disconnect the plug from the mains.
2. Cut the power cord.
3. Do not discard the product in usual domestic waste.
Disposal (in accordance with 2012/19/
EC):
The product must not be added to normal household
waste. It must be disposed of in line with local
environmental regulations.
Make sure that the product is discarded through or via
your municipal recycling collection centre.
(Fig. 5)
562 - 005 -
To stop the product on page

Transportation, storage and disposal

5. Lift the filter bag (A) and discard it.
6. Put the new filter bag in the dirt container (B).
7. Attach the cardboard part of the filter bag on
the vacuum inlet (C). Make sure that the rubber
membrane is passing past the heightening of the
vacuum inlet. (Fig. 35)
8. Put the motor unit on the dirt container and lock the
clasps. (Fig. 12)
15