Safety Instructions For Maintenance - Husqvarna WDC 220 Bedienungsanweisung

• flammable, explosive dust, for example
magnesium or aluminum dust.
Spare parts and accessories
CAUTION:
accessories for the safety of the product.
• Use only spare parts and accessories from
Husqvarna.
• Use only the brushes supplied with the product or
referred to in the operator's manual.
Explosive or flammable atmosphere
CAUTION:
explosive or flammable atmospheres. Do not
use the product near liquids, gas or fume
that can cause flammable atmospheres.
WARNING:
safety chapter before you assemble the
product.
To do before installation
1. Unlock the clasps and lift off the motor unit. (Fig. 8)
2. Remove the accessories from the dirt container.
(Fig. 9)
3. Make sure that all parts are included. See the
product overview. Necessary tools: Screwdriver.
To install the filter bag
1. Put the main switch to the "0" position.
2. Disconnect the product. (Fig. 10)
3. Unlock the clasps and lift off the motor unit. (Fig. 8)
4. Put the filter bag in the dirt container.
5. Attach the cardboard part of the filter bag on the
vacuum inlet. Make sure that the rubber membrane
is passing past the heightening of the vacuum inlet.
(Fig. 11)
6. Put the motor unit on the dirt container and lock the
clasps. (Fig. 12)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
12
Only use spare parts and
Do not use the product in
Assembly
Read and understand the
Operation
Before you operate the
Blower function
WARNING:
problems.The product has a blower function.
Do not blow the outgoing air randomly in
closed areas. Use the blower function only
with a clean hose.

Safety instructions for maintenance

WARNING:
instructions that follow before you do
maintenance on the product.
To empty the dirt container
CAUTION:
dangerous to the environment. Discard the
dirt referring to legal regulations.
To attach the accessories
1. Put the accessories in their position for easy access.
(Fig. 13)
2. Attach the tool box at the rear of the product. (Fig.
14)
3. Attach the holder for the the cable and the hose at
the rear of the product. (Fig. 15)
To install the hose
1. Put the hose in the vacuum inlet on the front of the
product. (Fig. 16)
2. Connect the appliance into the mains.
3. Put the main switch to the "I" position. (Fig. 17)
4. Adjust the suction power on the handle or by the
main switch*. *Only on some models. (Fig. 18)
To install the tube holder
1. Move the tube holder vertically on the extension
tube.
2. Use a screwdriver to install the tube holder on
correct height of the extension tube. (Fig. 19)
3. Park the extension tube at the holders on the rear of
the product. (Fig. 20)
To start the product
Before the product is used, make sure that the
frequency and voltage shown on the rating plate is the
same as the mains voltage.
Dust can cause health
Read all warning
Cleaned material can be
562 - 005 -