All manuals and user guides at all-guides.com
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
The dishes are wet.
The interior of the appliance
is wet.
Unusual foam during wash-
ing.
Traces of rust on cutlery.
There are residues of deter-
gent in the dispenser at the
end of the programme.
Odours inside the appliance.
Limescale deposits on the ta-
bleware, on the tub and on
the inside of the door.
Possible cause and solution
• The release quantity of rinse aid is too much. Adjust
the rinse aid level to a lower level.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
• For the best drying performance activate the option
XtraDry and set AirDry .
• The programme does not have a drying phase or
has a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try
a different brand or activate the rinse aid dispenser
and use rinse aid and multi-tablets together.
• This is not a defect of the appliance. it is caused by
the humidity in the air that condenses on the walls.
• Use the detergent for dishwashers only.
• There is a leak in the rinse aid dispenser. Contact an
Authorised Service Centre.
• There is too much salt in the water used for washing.
Refer to "The water softener".
• Silver and stainless steel cutlery were placed togeth-
er. Avoid to put silver and stainless steel items close
together.
• The detergent tablet got stuck in the dispenser and
therefore was not completely washed away by wa-
ter.
• Water cannot wash away the detergent from the dis-
penser. Make sure that the spray arm is not blocked
or clogged.
• Make sure that items in the baskets do not impede
the lid of the detergent dispenser from opening.
• Refer to "Internal cleaning".
• The level of salt is low, check the refill indicator.
• The cap of the salt container is loose.
• Your tap water is hard. Refer to "The water soften-
er".
• Even using multi-functional tabs use salt and set re-
generation of the water softener. Refer to "The wa-
ter softener".
• If lime scale deposits still remain, clean the appliance
with appliance cleaners which are particularly suita-
ble for this purpose.
• Try different detergent.
• Contact the detergent manufacturer.
ENGLISH
23