SICK DBS60 Core Betriebsanleitung Seite 24

OPERATING INSTRUCTIONS
3.10 Mounting of servo flange with servo-clamps
3.11 Mounting of with square flange
24 O P E R A T I N G I N S T R U C T I O N S | DBS60 Core
DBS60 Inox
• Block customer's drive shaft to prevent rotation.
• Mount the coupling (1) on the encoder
• Ensure that it does not touch the encoder flange.
•
Mount servo-clamps (2) with M3 screws (4).
• Do not fully tighten screws, turn the servo-clamps (2) such that the encoder flange
can be slid into the centering fixture (3).
• Slide the encoder together with the mounted coupling (1) onto the drive shaft and
centering fixture (3).
• Engage the servo-clamps (2) by rotating into the groove and tighten slightly. Mount
the coupling (1) on the drive shaft. The coupling must not be subjected to mechan‐
ical stress.
• Tighten up all 3 screws (4) on the servo-clamps (2).
• Establish an electrical connection with the power switched off.
• Switch on the voltage and check that the encoder is functioning.
2
1
3
Figure 12: Mounting servo flange with servo-clamps
• Block the customer's drive shaft.
• Install the coupling (1) on the encoder.
•
Ensure that the coupling (1) does not touch the encoder flange.
• Slide the encoder together with the mounted coupling (1) onto the drive shaft and
mounting spigot in the clamping direction (2).
• Install the encoder with 4 M5 screws (3) and washers (4).
• Install the coupling (1) on the drive shaft. The coupling must not be subjected to
any mechanical stress.
• Establish electrical connections with the voltage switched off. Switch on the power
and check the function of the encoder.
4
8017140/1EF5/2021-12-10 | SICK
Subject to change without notice