Yamaha RX-V557 Bedienungsanleitung Seite 72

TROUBLESHOOTING
Problem
Dolby Digital or DTS
sources cannot be
played. (Dolby Digital
or DTS indicator in
the front panel
display does not light
up.)
A "humming" sound
can be heard.
The volume level
cannot be increased,
or the sound is
distorted.
The sound effect
cannot be recorded.
A source cannot be
recorded by a digital
recording component
connected to this
DIGITAL OUTPUT
jack.
A source cannot be
recorded by an
analog component
connected to the
AUDIO OUT jacks.
The sound field
parameters and some
other settings on this
unit cannot be
changed.
This unit does not
operate properly.
"CHECK SP WIRES"
appears in the front
panel display.
There is noise
interference from
digital or radio
frequency equipment,
or this unit.
The picture is
disturbed.
This unit suddenly
turns into the standby
mode.
70
Cause
The connected component is not set to
output Dolby Digital or DTS digital
signals.
The input mode is set to ANALOG.
Incorrect cable connections.
The component connected to the OUT
(REC) jacks of this unit is turned off.
It is not possible to record the sound effect
with a recording component.
The source component is not connected to
this unit's DIGITAL INPUT jacks.
Some components cannot record the
Dolby Digital or DTS sources.
The source component is not connected to
this unit's analog AUDIO IN jacks.
"MEMORY GUARD" in SET MENU is
set to ON.
The internal microcomputer has been
frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.
Speaker cables are short circuited.
This unit is too close to the digital or high-
frequency equipment.
The video source uses scrambled or
encoded signals to prevent dubbing.
The internal temperature becomes too
high and the overheat protection circuitry
has been activated.
Remedy
Make an appropriate setting following the operating
instructions for your component.
Set the input mode to AUTO or DTS.
Firmly connect the audio plugs. If the problem
persists, the cables may be defective.
Turn on the power to the component.
Connect the source component to the DIGITAL
INPUT jacks.
Connect the source component to the analog AUDIO
IN jacks.
Select OFF.
Disconnect the AC power cord from the outlet and
then plug it in again after about 30 seconds.
Make sure all speaker cables are connected correctly.
Move this unit further away from such equipment.
Wait about 1 hour for this unit to cool down and then
turn it back on.
Refer to
page
—
32
—
—
14-18
14-18
53
—
12
—
—