Safety information
EN
Make sure there is no transport damage.
Remove all packaging and keep out of children´s reach and dis-
pose them in an environmentally friendly manner.
Wait at least two hours before installing the appliance in order to
Handle the appliance always with at least two persons because
it is heavy.
The appliance should be placed in a well-ventilated place.Ensure
a space of at least 10 cm above and around the appliance.
: Keep ventilation openings, in the appliance enclo-
sure or in the built-in structure, clear of obstruction.
Never place the appliance in a damp area or location where it
might be splashed with water.Clean and dry water splashes and
stains with a soft clean cloth.
Do not install your wine cellar in any location not properly insulat-
ed or heated (e.g. garage etc). Your wine cellar was not designed
to operate in ambient temperature below 16 °C.
Do not install the appliance in direct sunlight or in the near of
heat sources(e.g.stoves,heaters).
Install and level the appliance in an area suitable for its size and
use.
Make sure that the electrical information on the rating plate
agrees with the power supply.If it does not,contact an electri-
cian.
The appliance is operated by a 220-240 V /50 Hz power sup-
to start,or damage to the temperature control or compressor,or
there may be an abnormal noise when operating.In such case,an
automatic regulator shall be mounted.
Do not use multi-plug adapters and extension cables.