SCHUNK ERT 12 Montage- Und Betriebsanleitung Seite 90

Assembly
90 04.00 | ERT 12 / 50 / 300 | Assembly and Operating Manual | en | GAS0406665
1. Loosen the screws (1) and remove.
2. Remove seal mount (2), O-ring (4) and sealing ring (3).
NOTE
Thoroughly clean seal mount (2) and seal surfaces in the
housing.
3. Lubricate O-ring (4) and sealing ring (3) with prescribed grease
on the inner and outer diameter.
4. Place the sealing ring (3) in the seal mount (2).
NOTE
The notch of the sealing ring (3) must point in the direction of
the arrow (A).
5. Insert the seal mount (2) into the housing.
6. Tighten the screws (1).
Tightening torque: 1.2 Nm
✔