Inhaltsverzeichnis
Werbung
2. Clean the filter by hitting it against a flat surface.
Do not use solvent with petroleum, kerosene or
compressed air to clean the filter.
Note:
Air filters in operation for a long time
cannot be cleaned fully. Replace the air filter at
regular intervals. Damaged air filters must always be
replaced.
3. When you assemble the air filter, make sure that it
fully seals against the filter holder.
To do a check of the side discharge
deflector
The side discharge deflector is attached to the side
discharge opening of the product. It decreases the risk
of objects to eject in the direction of the mow position of
the operator.
1. Make sure that the side discharge deflector is not
damaged.
2. Examine the side discharge deflector. Make sure
that you do not see defects, such as cracks or
broken springs that push the door to close.
3. Replace the side discharge deflector or the springs if
they are damaged.
To examine the fuel system
•
Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
Transportation and storage
•
For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
•
Always use approved containers for storage and
transportation of fuel.
•
Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
•
Safely attach the product during transportation to
prevent damage and accidents.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Keep the product in a dry and frost free area.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
1583 - 007 - 07.10.2022
Transportation, storage and disposal
•
Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
To adjust the clutch wire
For the situations that follow, it is necessary to decrease
the length of the clutch wire:
•
The drive of the wheels does not engage when you
pull the drive bail or the speed control lever.
•
The product moves slowly when the drive of the
wheels is engaged.
For the situations that follow, it is necessary to extend
the length of clutch wire:
•
The product moves when the drive of the wheels is
not engaged.
•
Adjust the clutch wire.
a) To decrease the length of clutch wire, turn the
adjuster screw counterclockwise.
b) To extend the length of the clutch wire, turn the
adjustment screw clockwise. (Fig. 38)
If the product continues to drive unsatisfactory after the
adjustment, speak to you servicing dealer
15
Werbung
Inhaltsverzeichnis
