APRILIA eSR1 Benutzerhandbuch Seite 11

Method:
• Take the item out of the packaging
• Open the kickstand and check that the item is stable
• Open the handlebar stem and secure it by closing the lever of the closing mechanism
• Connect the display power cable to the main wiring
• Install the handlebar on the stem (do not crush the cables)
• Tighten the screws on the stem using the wrench supplied
• Adjust the stem closing mechanism*
Model Reference picture
eSR2
eSR2 EVO
eSR1
eSRZ
* Adjustment
There is a hex screw inside the mechanism.
If the handlebar stem is not very stable after
closing, adjust the screw in the mechanism,
by tightening or loosening it as required to
increase the stability of the stem.
Outside the mechanism there is a hex socket
screw. If the handlebar stem is not very
stable after closing, adjust the screw in the
mechanism, by tightening or loosening it as
required to increase the stability of the stem.
There is a hex screw inside the mechanism.
If the handlebar stem is not very stable after
closing, adjust the screw in the mechanism,
by tightening or loosening it as required to
increase the stability of the stem.
10