General Instructions; Electrical Connection (U.k. Only) - DeLonghi G010612R Betriebsanleitung

RAPIDO•INT 28-11-2000 09:01
GB
The Rapido heater is an extremely versatile heating appliance with 3 selectable power levels. The
Rapido also has one exclusive functions to ensure that the optimum comfort level is achieved in any
given situation.
In order to use this heater to its maximum potential we advise you to carefully read the instructions
given here.

1. GENERAL INSTRUCTIONS

Remove the appliance from its box and packaging and turn it over resting it on the protective polystyrene
packaging. Check that the appliance is intact, complete with the power cable and that it hasn't suffered
damage during transportation. Do not use the appliance if it is damaged.
2. ASSEMBLY OF THE BASE
Remove the castors, wheels and assemblies from the polystyrene packaging
Insert the castors into the pins of the feet and push them all the way in until a click can be heard (fig1) Make
sure that they are in tightly by pulling the wheels gently. Attach the castor assembly into the base of the control
panel by inserting the guiding ridges between the control panel and the first heating element; insert the two
location lugs into their housings and lock the castor assembly to the product by inserting the eye screws,
screwing them in tightly. (fig1) Fit the two rear wheels onto the rear wheel axle (fig 2). Check that the wheels
can turn freely. Finally turn the heater over to its upright position, ensuring you do not damage the wheels.
3. ELECTRICAL CONNECTION
Before inserting the plug into the electrical socket, make sure that the voltage of the socket corresponds to the
voltage requirement indicated on the appliance, and that the electrical socket and the mains supply to the
socket is rated at 13amps. It is important to ensure that the socket is adequately earthed.
This appliance complies with EEC Directive 89/336 relating to electromagnetic compatibility.
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut
off from the mains lead, and on appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative
plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover
must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover,
the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the
correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instructins provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Green and yellow Earth
Blue Neutral
Brown Live
Pagina 7

ELECTRICAL CONNECTION (U.K. ONLY)

As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The green and yellow wire must be connected to the
terminal in the plug marked with the letter E or the earth
symbol
The blue wire must be connected to the terminal
marked with the letter N or coloured black.
The brown wire must be connected to the terminal
marked with the letter L or coloured red.
or coloured green or green and yellow.
7