How Do I Know That My Camera Settings Are Correct; How Can I Reset The Interface To Factory Settings If I Don't Remember The Password Or Ip I Have Entered; I Am Connected By Cable But Cannot Access The Interface Web Server; What Format Should The Password I Enter Into The Interface Be In - Fermax DUOX PLUS Installationshandbuch

5.2 How do I know that my camera settings are correct?

1. Connect the IP camera to a POE switch or power it with an external power supply
2. Connect the PC to the same switch (the PC must be configured within the IP range of
the Interface (192.168.1.xx).
3. Open the VLC Media Player application and under Media
4. Write the RTSP URL of the camera example
and check that the camera is displayed correctly. This allows you to confirm correct
functioning and that the RTSP URL address is correct.
5.3 How can I reset the Interface to factory settings if I don't remember the
password or IP I have entered?
Press PRG for 10 seconds until the red LED blinks rapidly several times.
The default settings are:
• IP Address: 192.168.1.100
• Mask: 255.255.255.0
• User: admin (cannot be modified)
• No password. The first time you log in, you will be asked to create a new one.

5.4 I am connected by cable but cannot access the Interface web server.

Always remember to press PRG for 2 seconds to activate the web server. The white WiFi
LED will start blinking indicating that you may access the WiFi configuration.

5.5 What format should the password I enter into the Interface be in?

The password must have at least 8 digits and include uppercase letters, lowercase letters,
numbers and symbols.

5.6 What happens if I enter the wrong password into the Interface?

It will block access for 5 minutes after 3 unsuccessful attempts.

5.7 How can I exit the web server or configuration?

Access will be disabled after 5 minutes without any device connecting or 20 minutes after
the last activity. It shall also be possible to press the programming button for 2 seconds to
disable it manually.

5.8 Can I configure the Interface via my PC?

rtsp://admin:fermax123@192.168.1.205:554
Yes, your PC must be configured within the IP range of
the Interface (192.168.1.xx):
1st Connect the DUOX PLUS bus (24Vdc) to the
Interface. The red PWR LED will start blinking every
second.
2nd Connect the RJ-45 Ethernet cable directly from
the PC to the Interface or via switch.
3rd Press the programming button for 2 seconds to
activate the web server. The white WiFi LED on the
monitor will start blinking.
Open Network Location.
DUOX PLUS IP CAMERA INTERFACE
9