Before Use; Changing Tools; Torque Preselection/Selecting The Operating Mode; 2-Speed Gearbox - Parkside PNS 300 B3 Originalbetriebsanleitung

Before use

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.

Changing tools

Your appliance has a fully automatic spindle
lock .
When the motor is stopped, the power train
locks so that the chuck
turning it . After you have attached the desired
tool and tightened it by turning the chuck
can continue working. The spindle lock is automati-
cally released when the motor starts (ON/OFF
switch pressed).
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque selection
ring and select the drill setting .
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard mate-
rials or removing screws.
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position .
■ 6 │ GB │ IE
can be opened by
, you
to the

2-speed gearbox

CAUTION!
► Operate the speed selector switch
when the appliance is at a standstill. Other-
wise, the appliance could be damaged.
In first gear
(speed selector switch
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear
(speed selector switch
you can reach a speed of approx. 1600 rpm for
carrying out drilling work.

Removing the chuck

If you want to use the bit holder
remove the chuck .
Removing the chuck
♦ Hold the chuck
♦ Pull/push the chuck ring
the chuck .
The chuck is now unlocked and can be
removed towards the front.
Attaching the quick-release chuck
♦ To replace the chuck
towards the quick-release chuck and push the
chuck fully on.
NOTE
► If the chuck does not automatically click
into place, turn the chuck ring

Using the bit holder

After removing the chuck
holder .
♦ Insert a suitable bit into the bit holder
♦ Push the bit into the bit holder
stop.
The guidance and the magnetic holder keep the
bit firmly in place.
♦ To remove the bit, pull it out of the bit holder
only
in position: 1)
in position: 2)
, you must
firmly from the front.
in the direction of
, pull the chuck ring
.
you can use the bit
.
as far as the
PNS 300 B3
.