Pausing Operation Of The Steam Iron; After Use; Drip-Stop Function; Automatic Switch-Off - Silvercrest SDB 2400 F4 Bedienungsanleitung

All manuals and user guides at all-guides.com

Pausing operation of the steam iron

WARnInG – RISK oF FIRE!
► Never leave a hot steam iron unattended if it is switched on or connected
to the mains power supply .
1) Move the temperature control 8 to the "MIN" position .
2) Stand the steam iron only on the base 0 .

After use

■ Remove the plug from the mains power socket .
■ Empty the water tank and clean the sole of the iron q .
■ Place the cooled-down steam iron on the base 0 .

Drip-stop function

With conventional steam irons, water can drip from the sole of the iron q at
low temperatures . This iron however, possesses a new feature, the DRIP-STOP
function . At low temperatures, the iron automatically switches off the steam-
blast function . When this happens, you will hear a "CLICK" . Then set a suitable
temperature with the temperature control 8 . As soon as this is reached, steam
production is resumed .

Automatic switch-off

This steam iron is fitted with an automatic switch-off system . This stops the iron
from heating up .
If the iron is resting on the sole of the iron q and is not moved for about 30
seconds, you will hear a warning beep and the control lamp for the automatic
switch-off 6 will flash . The iron will stop heating up . To deactivate the automatic
switch-off, lift up the iron and move it gently from side to side . The control lamp
for the automatic switch-off 6 goes out and the iron will heat up again .
If the iron is on its base 0 and is not moved for about 8 seconds, there will be a
warning beep and the control lamp for the automatic switch-off 6 flashes . The iron
will stop heating up . To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side . The control lamp for the automatic switch-off 6
goes out and the iron will heat up again .
SDB 2400 F4 GB │ IE │ 23 ■