Plug In The Power Cable - Polk XT10 Schnellstartanleitung

Connect the subwoofer to your amplifier or AVR
3
Select one of the two options below to connect the subwoofer to your amplifier or receiver.
NOTE: Make sure the subwoofer isn't plugged into AC power before connecting it to your amplifier/receiver.
Line in setup
This method is recommended for systems with no LFE/subwoofer output jack, such as 2-channel systems.
1. Turn off the power on your amplifier/receiver.
2. Connect standard RCA cables from the front left and right pre-out jacks of the amplifier/receiver.
3. Set the volume knob to the 12 o'clock position.
4. Adjust the low-pass filter knob to blend the subwoofer and main speakers to your preferences.
LFE setup
1. Turn off the power on your amplifier/receiver.
2. Connect the LFE cable from your receiver to the left white RCA line input on the subwoofer.
NOTE: The 'left white RCA line input' is labeled as 'L/LFE'.
3. Turn the low-pass filter knob on the subwoofer to 160 Hz.
4. Set the volume knob to the 12 o'clock position.
5. Follow the bass management instructions on your amplifier or AVR to integrate the subwoofer.
4

Plug in the power cable

Plug the power cable into the subwoofer, then into a wall outlet.
5 Setup is now complete!
Watch TV or listen to music and adjust the subwoofer settings to your preferences. See the next page for a
diagram of the subwoofer back panel.
For support, FAQs, and more information about the subwoofer, visit polkaudio.com/MonitorXT10.