To Adjust The Front Wheel Toe-In And Camber - Husqvarna TC 242TX Bedienungsanweisung

• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transaxle fan and cooling fins.
• Examine the cooling fan to make sure the fan blades
are clean and not damaged.
To examine the transaxle pump fluid
• Make sure that the transaxle pump fluid does not
leak.
• Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.

To adjust the front wheel toe-in and camber

The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are not
adjustable.
• Speak to an approved service center if the factory-
set front wheel toe-in or camber is damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover on
its sides. Tilt the engine cover in the direction of the
engine and lift it to remove it from the product.
4. Install in the opposite sequence.
1923 - 005 - 13.10.2022
A
To remove the movement drive belt
B A
C
D
E
F
1. Park the product on a level surface.
2. Engage the parking brake. Refer to
disengage the parking brake on page 19 .
3. Remove the cutting deck. Refer to
install the cutting deck on page 29 .
Note:
Be careful with the movement drive belt and
the position of the belt guides and belt keeper.
4. Disconnect the clutch wire harness (A).
5. Remove the belt keeper (B) on the right side of the
product.
6. Remove the movement drive belt from the stationary
idler pulley (C), and the clutch idler pulley (D).
7. Remove the movement drive belt from the center
idler pulley (E).
8. Pull the movement drive belt to the rear part of the
product. Carefully remove the movement drive belt
from the transmission input pulley and above the
cooling fan blades (F).
9. Remove the movement drive belt from the engine
pulley and around the clutch pulley (G).
10. Move the movement drive belt to the rear part of the
product and off the steering plate (H).
11. Remove the movement drive belt from the product.
G
H
I
To engage and
To remove and
27