Switch On / Switch Off; Heating/Cooling Mode; Setting The Desired Temperature - Bio Green THERMO 2 Installations- Und Gebrauchsanweisungen

Thermo 2 Operating Instructions / Bruksanvisningen
4.0 Operation
Check that no damage has occurred to the unit or the mains cable during installation. Also make sure that the
sensor cable has not been bent sharply, as this may impair its function.

4.1 Switch on / switch off

As soon as the unit has been connected to the supply voltage, it can be switched on using the key
"Switch on/off". To do this, hold down the button for 3 seconds. Immediately after switching on, the Thermo
2 determines the ambient temperature of the sensor and shows it in the display. To switch it off, press the
"Switch on/off" button again for 3 seconds.

4.2 Heating/cooling mode

Use the button "Heating/cooling" to switch between heating and cooling mode. Press and hold the
button for 3 seconds to change the mode. The display shows for 4
seconds "H" for heating or "C" for cooling. At the same time, you can see the mode set in each case via the
LEDs. The red LED stands for heating and the green LED for cooling.

4.3 Setting the desired temperature

Briefly press the button
temperature in a flashing rhythm. Use the keys
range: -50°C to +99°C). After the setting, the value is automatically saved and the menu is exited after 3
seconds. The display now shows the current ambient temperature again.
Status indicator light
Red Signals: "Heating
Status indicator light Yellow signals: "Set
temperature not yet reached".
Status indicator light
Green Signals: "Cooling
Push button "Up
for temperature
adjustment
Down" push button
for temperature adjustment
BioGreen GmbH | Marburger Str. 1b | 35649 Bischoffen-Oberweidbach
or to enter the setting mode. The display now shows the currently set
18
and to change the temperature in 1°C steps (setting
Digital temperature display
(three-digit display)
°C
EN
Heating/cooling mode+
switch Celsius/
Fahrenheit
On-Off Switch