Electrical Safety - Black & Decker KA293 Anweisungen

E N G L I S H
18. Store idle tools
When not in use, tools should be stored in a
dry, locked up or high place, out of reach of
children.
19. Maintain tools with care
Keep cutting tools sharp and clean for better
and safer performance. Follow the instructions
for maintenance and changing accessories.
Keep handles and switches dry, clean and free
from oil and grease.
20. Repairs
This tool complies with relevant safety
requirements. Repairs should only be carried
out by qualified persons using original spare
parts; otherwise this may result in considerable
danger to the user.
Additional safety instructions for sanders
Preferably wear a dust mask whenever
sanding.
Thoroughly remove all dust after sanding.
Take special care when sanding paint which is
possibly lead based or when sanding some
woods and metal which may produce toxic
dust:
- Wear a dust mask specifically designed for
protection against lead paint dust and fumes
and ensure that persons within or entering
the work area are also protected.
- Do not let children or pregnant women enter
the work area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other
debris safely.
Before using the tool on wooden
workpieces, preferably fit the dustbag.
Before using the tool on metal
workpieces or workpieces containing
metal, make sure to remove the
dustbag.
Wear gloves when working with metal
workpieces.
8
Wear safety glasses or goggles when
working with metal workpieces.
Wear ear protection when operating this
tool.

ELECTRICAL SAFETY

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
This tool is double insulated in accordance
with EN 50144; therefore no earth wire is
required.
Mains plug replacement (U.K. & Ireland only)
Should your mains plug need replacing and
you are competent to do this, proceed as
instructed below. If you are in doubt, contact
an authorised repair agent or a qualified
electrician.
Disconnect the plug from the supply and
remove the fuse from the plug.
Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see above).
Brown is for Live (L) (2), blue is for Neutral (N) (4).
Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.