Switching On And Off; Optional Accessories - Hilti NURON TE 6-22 Original Bedienungsanleitung

5.8 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1

Switching on and off

1. To switch the product on, press the control switch.
▶ Speed can be controlled steplessly by varying how far the control switch is pressed in.
2. To switch the product off, release the control switch.
6.2 Direction of rotation
▶ Set the direction of rotation.
▶ The selector switch engages in this position.
6.3 Function switch
Set the function selector switch to the desired function.
Risk of damage! Do not operate the function selector switch while the motor is running.
Drilling without hammer action
•
Set the function selector switch to
Hammer drilling
• Set the function selector switch to
Chisel positioning
•
Set the function selector switch to
Chiseling
•
Set the function selector switch to
7

Optional accessories

7.1 TE DRS­4⁄6 (01) dust removal module
The TE DRS­4⁄6 (01) dust removal module is an accessory for the SDS­Plus rotary hammer drill. It collects
a high percentage of the dust generated and can be quickly and easily attached to the SDS­Plus rotary
hammer drill. The dust removal module has a built-in extractor fan. This fan is driven by its own motor. When
the SDS­Plus rotary hammer drill is switched on, the dust removal module draws its power from the battery
of the SDS­Plus rotary hammer drill.
*2264935*
6
7
.
.
.
.
8
2264935 English 23