Duronic BG200 Gebrauchsanleitung Seite 13

Note:
• If during grinding the coffee beans do not drop properly into the lower burr(4),
turn the grinder off and use a spoon to stir the beans. Then turn on the
machine again.
• The grinder should stop grinding automatically after the timer dial returns
back to the '0' mark.
• If the coffee beans run out whilst mid-grinding, switch off the grinder and refill
before continuing.
• Do not use the grinder continuously for more than 60 seconds at a time. The
recommended run time is no more than 60 seconds at a time. After 3 cycles
of this, leave the grinder to cool down for 30 minutes to avoid the motor
overheating.
CAUTION:
• Do not add coffee beans to the cup while the grinder is switched on
at the plug.
• Do not insert fingers inside the bean cup at any time. If the beans
do not drop properly into the burr, switch the machine off and use a
spoon to dislodge the beans.
13